Table of Contents
Advertisement
9) SATA0/SATA1 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and
1.5Gb/s standard. Each SATA connector supports a single SATA device.
SATA0 SATA1
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
are configured, the total number of hard drives must be an even number.
• A RAID 10 configuration requires four hard drives.
(Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of
the RAID configuration may vary depends on the devices are connected.
10/11) SATA_DOM0/SATA_DOM1 (SATA port 0 and port 1 DOM Jumpers)
CAUTION!
• If the SATA DOM power is supplied by the motherboard, set the jumper to pin 1-2.
• If the SATA DOM power is supplied by external power, set the jumper to pin 2-3.
• If a SATA type hard drive is connected to the motherboard, please ensure the jumper is closed
and set to 2-3 pins (Default setting), in order to reduce any risk of hard disk damage.
Please refer to the pin definition table in the following.
SATA_DOM0
SATA_DOM1
Hardware Installation
When SATA_DOM0/1 jumper
are set to 1-2 pin:
Pin No. Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
P5V
1
1
- 25 -
1
1
7
7
When SATA_DOM0/1 jumper
are set to 2-3 pin:
Pin No. Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
For SATA_DOM0
Pin No. Definition
1
P5V
2
SATA_DOM_0
3
GND
For SATA_DOM1
Pin No. Definition
1
P5V
2
SATA_DOM_1
3
GND
Advertisement
Table of Contents
