Related Manuals for ELSYS.se LoRaWAN ERS Desk
Summary of Contents for ELSYS.se LoRaWAN ERS Desk
- Page 1 Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se Specifications in this document are subject to change without notice. ©Elektroniksystem i Umeå AB 2020...
-
Page 2: Important Safety Information
For additional information and how to carry out disposal, please contact the certified disposal service providers. The sensors contain a lithium battery, which must be disposed of separately. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 3: Table Of Contents
Specifications ..........................16 Sensor payload format ......................16 Regulations ............................17 Legal Notices ..........................17 Federal Communication Commission Interference Statement .......... 17 Declaration of conformity ......................18 Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 4: Description
NFC (Near Field Communication) and can easily be configured from a smartphone. The barcode contains DevEUI and sensor type. This label is located at the back of your device, Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 5: Main Features Of Ers Desk
• Supported channel plans: US902-928, EU863-870, AS923, AU915- 928, KR920-923, RU864, IN865 & HK923 • CE Approved and RoHS compliant *Depending on settings and environmental factors Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 6: Installation
The blue and red areas are the ranges of the two different occupancy sensors, make sure that the thermopile sensor is facing the front as shown. 1. Remove the back panel of the sensor with a small screwdriver. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... - Page 7 Mount the back panel securely to the wall with at least 2 appropriate screws, using some of the six mounting holes. 4. Attach the sensor part to the back panel. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se...
-
Page 8: Service And Maintenance
Service and maintenance No serviceable parts inside. If service is needed other than battery replacement, please contact your distributor. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 9: Sensor Configuration
7. Wait for the sensor to reboot (5 sec), indicated by the LED flashing. Sensor settings have been updated. See the section “Help” in the application for more information. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 10: Over The Air Configuration
When you have written data to the sensor, let the sensor reboot and restart before trying to write again. You should always validate your settings by reading the NFC data after the sensor has restarted. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 11: Sensor Startup
After successful connection to a network, the sensor sends a settings packet and enters sampling mode. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 12: Sampling Mode / Periodic Measurement
Note: The configured sending interval can be overridden by network limitations. Due to this, the spreading factor and sending interval settings might result in longer intervals than intended. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 13: Motion Detection Range
Note: The PIR Lens has a blanking time of 20 seconds right after motion event and transmission. Any movements during this time will be ignored PIR Lens detection pattern Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 14: Desk Occupancy
• Examples of occupancy values: Occupancy 0: Unoccupied. • Occupancy 1: Occupied but pending, meaning someone is either • entering or leaving. Occupancy 2: Occupied. • Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... - Page 15 Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se...
-
Page 16: Specifications
Up to 8 years** *Measured with settings: SF10, 868 Mhz. The range can be greater or less, depending on terrain and building structure. **Depending on settings and environmental factors. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 17: Regulations
(1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. FCC ID: 2ANX3-ERS01 IC ID: 26904-ERS01 Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se... -
Page 18: Declaration Of Conformity
Declaration of conformity å Hereby, Elektroniksystem i Ume AB declares that ERS Desk complies with the essential requirements and other relevant provisions of Directive 2014/30/EU and 2014/53/EU. Elektroniksystem i Umeå AB Industrivägen 12, 90130 Umeå, Sweden E-mail: support@elsys.se ǀ Web: www.elsys.se...
Need help?
Do you have a question about the LoRaWAN ERS Desk and is the answer not in the manual?
Questions and answers