Pet Hair Turbine Tool; Agitator Maintenance - LG LUV200R Owner's Manual

CARE & CLEANING
3. Wash the filter cleanly in flowing water.
4. Remove moisture.
5. Dry completely away from sunlight.
6. Make sure to push down on the filter until it locks
in place before closing the exhaust filter cover.

Pet Hair Turbine tool

To clean the Pet hair turbine tool
1. Remove the four screws on the bottom of the
Pet hair turbine tool.
2. Lift off the cover.
3. Remove any debris.
To reassemble:
4. Carefully press cover onto tabs until they snap
into place.
5. Insert and tighten screws removed in Step 1.
Do NOT overtighten the screws.
Do Not use the pet hair turbine tool on any
animal.
1
18
2

Agitator Maintenance

WARNING
Electrical shock and personal injury hazard.
Always unplug the vacuum cleaner before
servicing. Failure to do so could result in
electrical shock or personal injury.
Frequently check the agitator brush area for hair,
string and lint buildup.
Remove the Agitator Brush Cover:
1. Unplug the vacuum cleaner. Press the left foot
pedal to release the head. Lower the handle until
the vacuum cleaner is lying flat on the floor.
2. Turn the vacuum cleaner over, so that the
agitator is facing up.
3. Set the agitator on a cloth or a smooth surface.
Remove the six screws on the bottom of the
head and remove the cover.
Carefully remove any accumulated string, hair,
4.
etc. from the agitator and the agitator area.
To reinstall the cover.
Reverse the steps above.