Table of Contents
Advertisement
HP R100-Series Wireless VPN Routers Quickstart
Placing on a desktop
The HP R110/R120 can also be installed on a desktop using the rubber feet.
Attach the included four rubber feet to recessed areas on the bottom of the
HP R110/R120, and then place it on the desktop in the preferred location.
Desktop mounting
1: Rubber feet
2: HP R110/R120 feet
location
Initial configuration
This procedure describes how to perform initial configuration for a factory-
default HP R110/R120. For illustration purposes, a simple scenario is used.
In this scenario, the HP R110/R120 links wired and wireless computers to the
Internet through a cable modem provided by an Internet Service Provider (ISP).
For instructions on how to configure other scenarios, see the HP R100-Series
Wireless VPN Routers Configuration/Administration Guide.
2
1
Simple scenario
1: Wired computer
2: AC/DC power adapter
3: HP R110/R120
3
4
6
4: Cable modem
5: Internet
6: Wireless computer
4
The HP R110/R120 is managed through its web-based management interface
using Microsoft Internet Explorer 8 or later, Google Chrome v29 or later, or
Mozilla Firefox v24 or later.
You must perform the initial configuration from a computer that is directly
connected to one of the HP R110/R120 LAN ports. If you configure the HP
1
R110/R120 from a wireless computer, you might lose contact with the HP
R110/R120 when you change the wireless configuration.
Note: Do not power on the HP R110/R120 until directed.
2
A. Configure your computer
1.
Verify that the Ethernet network interface of your computer is set to
obtain an IP address automatically from DHCP.
2.
Disable any wireless connection on your computer.
B. Connect cables and power on the HP R110/R120
1.
Connect your cable modem to the WAN port on the HP R110/R120 using
a standard Ethernet cable.
2.
Connect the LAN port on your computer to one of the LAN ports on the
HP R110/R120 using a standard Ethernet cable.
3.
Connect other equipment to the LAN ports using standard Ethernet
cables.
4.
Connect the AC/DC power adapter to the power socket on the HP R110/
R120, and then plug the AC/DC power adapter into a standard electrical
wall socket.
5.
Power on the HP R110/R120 by pressing the power button.
Initially, the HP R110/R120 LAN port LEDs turn on and off. Wait
approximately one minute until the Alert LED turns off before proceeding
to the next step.
5
C. Connect to the management interface and log in
Note: A factory-default HP R110/R120 is assumed.
1.
In a web browser, enter the address: https://192.168.1.1.
2.
On the Login page, specify admin for both Username and Password,
and then select Login.
Note: HP recommends that you change the default password on the System >
Admin page and select Save. Passwords must be at least six characters
long and include four different characters.
3.
On the License Agreement page, read the agreement and select Accept
HP End User License Agreement.
Initial configuration
Advertisement
Table of Contents
