General Information - LG LSSC243ST Owner's Manual

Vacation time
Power failure
If you move
Anti condensation
pipe
When LED lamp
doesn't light up
Exterior
Interior
After cleaning
WARNING

General information

During average length vacations, you will probably find it best to leave the refrigerator
in operation. Place freezable items in freezer for longer life.
When you plan not to operate, remove all food, disconnect the power cord, clean the
interior thoroughly, and leave each door OPEN to prevent odor formation.
Most power failures that are corrected in an hour or two will not affect your
refrigerator temperatures.
However, you should minimize the number of door openings while the power is off.
Remove or securely fasten down all loose items inside the refrigerator.
To avoid damaging the height adjusting screws, turn them all the way into the base.
The outside wall of the refrigerator cabinet may sometimes get warm, especially just
after installation. This is due to the anti-condensation pipe, which pumps hot refrigerant
to prevent sweating on the outer cabinet wall.
Is LED lamp turned on?
- LED lamp is not a user-serviceable item.
If the LED array fails, contact LG for service.
Cleaning
It is important that your refrigerator be kept clean to prevent undesirable odors. Spilled
food should be wiped up immediately, since it may acidify and stain plastic surfaces if
allowed to settle.
Use a lukewarm solution of mild soap or detergent to clean the durable finish of your
refrigerator.
Wipe with a clean damp cloth and then dry.
Regular cleaning is recommended. Wash all compartments a baking soda solution or a
mild detergent and warm water. Rinse and dry.
NOTE
Please do not use a dishwasher to clean the lower drawers; the high temperature
•
may cause damage to the baskets, making them unusable.
Please verify that the power cord is not damaged or overheated. Also verify the power
plug is inserted completely into power outlet.
Always remove power cord from the wall outlet prior to cleaning in the vicinity of
electrical parts (lamps, switches, controls, etc.).
Wipe up excess moisture with a sponge or cloth to prevent water or liquid from
getting into any electrical part and causing an electric shock.
Never use metallic scouring pads, brushes, coarse abrasive cleaners, strong alkaline
solutions, flammable or toxic cleaning liquids on any surface.
Do not touch frozen surfaces with wet or damp hands, because they could stick or
adhere to extremely cold surfaces.