Operation; Start-Up Procedure; Starting The Engine - KDAR Hot Max Torches PW3600 Operator's Manual

Pre-Start Preparation
NOTE: The following procedures are to be
completed each time the power washer is start-
ed.
1. Before using the power washer, check to make
sure there are no loose or missing parts.
WARNING
The power washer must not be operated if all
factory installed heat shields are not in place.
Failure to comply may result in the fuel tank
over heating which could cause personal injury
from fire.
Start Up Procedure
1. Make sure water supply is connected and
turned on.
2. Release the safety lock on the gun if it is
locked.
3. Depressed the gun trigger until a steady stream
of water is flowing from the nozzle.
4. Remove any dirt or obstructions from the gun
outlet, nozzle and the male connector of the
wand.
5. Insert the wand into the gun and nozzle into
the wand.

Starting the Engine

1. Check the oil and fuel levels.
2. Open the fuel shut off valve.

Operation

3. Slide the choke and throttle left (if starting a
cold engine).
4. Turn ON/OFF switch to the ON position
5. Pull starter rope with a fast steady pull.
6. As engine warms up return choke back to open
position
DANGER
KDAR Company
ON
Starter
Rope
Handle
Provide adequate ventilation for
•
toxic exhaust gases and cooling air
flow.
Do not start or run the power wash-
•
er in and enclosed area, even if win-
dows or doors are open.
Engines give off carbon monoxide, a
•
odorless colorless, poison gas.
Breathing carbon monoxide can
•
cause nausea, fainting or death.
7