Summary of Contents for KDAR Hot Max Torches PW2000
Page 1
Power Washer Model: PW2000 WARNING: Do not assemble, install or operate this equipment without reading ALL of this manual and the safety precautions and warning illustrated in this manual. KDAR Company Tel: (636) 493-9920 3671 New Town Blvd Fax: (636) 493-9921 St.
Page 2
In rain or inclement weather. 5. Always remove the spark plug or spark 11. Do not allow the hose to be in contact plug cable before performing mainte- with the muffler when it is hot. nance to avoid accidental starting. KDAR Company...
Page 3
33. Drain fuel before transporting the power trapped. DANGER—CARBON MONOXIDE HAZARD: The engine washer. exhaust contains carbon monoxide, 34. Power washers are heavy, use proper a poisonous, odorless, invisible gas lifting techniques. which, if breathed, may cause death or personal injury. KDAR Company...
Repeat for the other wheel assembly. Oil Filler 4. Fill with .63 quarts (.6 Li- ters) of motor oil. 5. Confirm proper fill by re- placing the dip stick and checking the oil level. KDAR Company...
State of California and on some U.S. Forest Ser- 4. Never use stale or contaminated gasoline or vice Land and may also be legally required under oil/gasoline mixture. KDAR recommends a other statutes and ordinances. The California stat- fuel stabilizer.
Do not start or run the power wash- • er in and enclosed area, even if win- dows or doors are open. Engines give off carbon monoxide, a • odorless colorless, poison gas. Breathing carbon monoxide can • cause nausea, fainting or death. KDAR Company...
Note: The force of the spray on the surface be- parts of this pressure washer should be used. ing cleaned increases as the nozzle is moved KDAR assumes no responsibility for damages closer to the surface. cause by chemicals used with this pressure washer.
(a nonflammable or high flash 1. Unsnap the air cleaner cover clips. point solvent can also be used). 2. Remove the air filter element. 3. Re-install Arrestor and tighten Clamp. KDAR Company...
Never use spark plugs which have an improper If the engine has been running the muf- heat range. Use only the recommended spark fler will be very hot. Care must be taken plugs or equivalent. not to touch the muffler when removing the spark plug. KDAR Company...
Page 12
This screen is located inside the water supply connection. 1. Stop the pressure washer. 2. Detach the garden hose. 1. Carefully, remove the screen. 2. Thoroughly wash the screen. KDAR Company...
Page 13
Storing the engine in Change the engine oil. this position will help protect it from internal • corrosion. KDAR Company...
2. Fuel should flow from the drain when the fuel valve is turned on. If the engine still does not start, take the genera- NOTE: The nearest KDAR authorized ser- tor to a authorized vice center can be found by visiting KDAR service center.
Page 15
Unit stored in freezing temperatures? Thaw unit completely, including hose, gun and wand. If pressure is still not restored, take the power washer to a authorized KDAR ser- vice center. No Intake of Chemicals Is injection tube securely attached to unit? Attach tube securely to unit.