Engine Preparation - KDAR Hot Max Torches PW3600 Operator's Manual

Wheel, Handle & Holder Assembly
Note: All fasteners can be tightened as each
procedure is completed. There is no need to
wait until assembly is complete to tighten the
fasteners.
1. Using 2 M6x40 bolts, 2 M6 nuts and 2 M6
washers, attach the handle to the main frame.
2. Using 2 M6x45 bolts, 2 M6 nuts and 2 M6
washers, attach the handle holder to the right
side of the power washer handle.
3. Using 2 M6x45 bolts, 2 M6 nuts and 2 M6
washers, attach the hose holder to the left side
of the power washer handle.
4. Insert wheel axle into the axle support tube by
depressing the detent pin. Be sure to align the
detent pin with the pin hole in the axle. Repeat
for the other wheel assembly.
Set Up

Engine Preparation

Engine Oil
NOTE: Engine oil is a major factor affecting
the performance and service life of this power
washer. Non-detergent and 2-stroke engine oils
WILL damage the engine and are not recom-
mended.
1. Use 4 stroke oil, or an equivalent high deter-
gent, premium quality motor oil certified to
meet or exceed U.S. automobile manufactur-
er's requirements for Service Classification
SG, SF/CC, CD. This designation will be on
the motor oil container.
2. SAE 10W-30 is recommended for general, all-
temperature use. See chart for appropriate
weights for your area.
3. Locate the oil filler cap and remove.
4. Fill with .63 quarts (.6 Li-
ters) of motor oil.
5. Confirm proper fill by re-
placing the dip stick and
checking the oil level.
KDAR Company
Oil Filler
Cap
5