Current Setpoint Control: Temperature Modification - Riello NEXPOLAR Manual

CONTROL UNIT PROGRAMMING
− To confirm, press and hold down the
Home button for 2 seconds.
2 sec.
− The block icon will be displayed
Example: Home mode blocked
To cancel the bocked status
− Press and hold down the Home but-
ton for 2 seconds.
2 sec.
− The display will show the remaining
time. Set the counter to "0" by press-
ing the Down button
− To confirm the operation, press and
hold down the Home button for 2
seconds
2 sec.
− The block icon
the program will be reactivated.
THU
will disappear, and
3.4 Current setpoint control:
Temperature modification
Two different configurations can be availa-
ble:
− If the user interface is installed on the
unit, the setpoint control is based on
.
the water's output temperature.
− If the user interface is installed inside
a room (remote user interface), the
setpoint control is based on the room
temperature.
Control type
Local
Remote
In order to obtain improved comfort, the
current setpoint can be adjusted based on
the user's needs.
To adjust the setpoint
− To decrease the temperature, press
the Down button.
− To increase the temperature, press the
Up button.
NOTE: After a predefined period of inactiv-
ity (with no button being pressed),
the setpoint information (air or water
temperatures to be reached) is ob-
scured. By default, the time-out is 10
minutes.
10
Current setpoint
Water setpoint
Air setpoint