Table of Contents
Advertisement
Operating Instructions and Parts List
Installation Procedures
This filter should only be installed
by qualified personnel.
EQUIPMENT INSPECTION
Carefully inspect equipment before
installing. Occasionally, products are
damaged in transit. Any damaged
filter components can cause failure and
should be replaced immediately.
1. The filter system should be installed
on a level concrete slab or other rigid
base. Select a well drained and
vented area, one that does not flood
when it rains. Position the filter so that
the piping connections, and winter
drain are convenient and accessible
for operation, service, maintenance
and winterizing.
2. Position filter body such that all
operation and safety labels are
visible.
3. Position filter so the filter will drain by
gravity.
4. If practical, place pump and filter in
the shade to shield it from
continuous, direct heat from the sun.
5. Connect the pool suction plumbing
between the skimmer, pool suction
outlet (from the pool) and the pump.
6.
Connect the pump discharge
(pump OUTLET) to the filter
INLET.
5
7. Connect the bottom filter port
(filter OUTLET) to the pool
return plumbing lines.
8.
Do not locate pump controls over
or near filter.
Verify water discharge from the
manual air relief valve (MAR) is
9.
directed away from electrical
devices.
OUTLET
INLET
Advertisement
Table of Contents
