Table of Contents
Advertisement
BLUETOOTH OPERATION
2
PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION
1) Power on the MC900B by pressing and holding down the Power
seconds, the Bluetooth blue LED will start to flash, and a confirmation tone will be heard
from the speakers signalling that the MC900B is now ready for Bluetooth pairing.
NOTE: You have 2 minutes before you must restart this procedure over again.
2) Now that the MC900B is in pairing mode:
ANDROID users:
a. Go into the Settings Menu of your device
b. Enter the Bluetooth Menu and press SCAN
c. "MC900B" will now be display under AVAILABLE DEVICES
d. If prompted, enter passcode: "0000"
iOS users:
a. Go into the Settings Menu of your iOS device
b. Enter the Bluetooth Menu
c. "MC900B" will now be displayed
d. If prompted, enter passcode: "0000"
3) If the MC900B is not seen, repeat the above steps to refresh the "Device List"
4) When the connection is successful you will hear a confirmation tone, you are now ready
to stream music from your devices favorite media player to the MC900B
To avoid battery exhaustion be sure to run the vehicles engine
Tips:
EN
while using this product. Using this product without running the
engine can drain the battery.
7
5V 1A
USB CHARGE
5
Nyne Cruiser
RECONNECTION
2
button for 2
1) Power on the MC900B and your last paired device Bluetooth.
2) The unit will now automatically reconnect, and a confirmation tone will be heard from the
speakers
3) If your device was previously paired with the BOSS AUDIO MC900B, but it wasn't the
last paired device:
4) If the device is out of range from the MC900B, it will disconnect automatically:
CLEARING PREVIOUSLY PAIRED DEVICES MEMORY
1) Quick press the POWER
2) Press and hold the PLAY/PAUSE
the speakers will be heard, the LED's will stop flashing, now only the BT LED will flash
3) PAIR a new device as described on PG 8
BLUETOOTH OPERATION
2
a. Ensure no other devices are currently paired
b. Enter the Bluetooth Menu on your device being paired
c. "MC900B" will display under AVAILABLE DEVICES
d. Choose the "MC900B" to reconnect
a. To reconnect once device is back in range, press the Power
b. The MC900B will now reconnect to the device, a confirmation tone will be heard
from the speakers
2
button 2X, all BLUE LED's will start to flash
5
button for 10 seconds, a confirmation tone from
5V 1A
USB CHARGE
Nyne C
2
button once
8
Advertisement
Table of Contents
