Advertisement
BUTTONS AND DISPLAYS
Cal. S141A
[TIME/CALENDAR mode]
Button B (SELECT)
Selection of the digits to be adjusted
Identification number
[STROKE mode]
[STOPWATCH mode]
Button B (LAP/SPLIT, RESET)
With each press of the button after the
measurement is started, split time and
lap time are measured.
By pressing the button to end the
measurement, the new block number
for the next measurement is displayed.
STOPWATCH mode indicator
Activation/deactivation of the contrast adjustment function
Button B (RESET)
Memory number
Split/lap number
Button C (CONTRAST)
Button C (MEMORY RECALL)
Button C (MEMORY RECALL)
- 8 -
Cal. S141A
Button A (SET)
Setting the digits to be adjusted
Year
Month and date
Time
It is displayed in the 24-hour indication.
TIME/CALENDAR mode indicator
Block mark
The block mark on the display: the block
memory mode
No block mark on the display: the single
memory mode (in any display mode)
The illustration shows the block mark
appearing on the display.
Button D (CHANGEOVER OF MODES)
With each press of the button, the mode
changes over in the following order.
➧
TOTAL TIME display of
the STOPWATCH mode
LAP TIME IN PROGRESS display
of the STOPWATCH mode
STROKE mode
TIME/CALENDAR mode
Button A (START/STOP)
Restart and stop of the stroke measure-
ment is repeated by pressing the button.
Number of stokes per minute
STROKE mode indicator
Button D (CHANGEOVER OF MODES)
Button A (START/STOP)
Restart and stop of the stopwatch can be
repeated by pressing the button.
Split time
(Hour, minutes, seconds and 1/100 seconds)
Lap time
(Hour, minutes, seconds and 1/100 seconds)
Total time
(Hour, minutes, seconds and 1/100 seconds)
Memory capacity indicator
Indication of the available memory
Button D (CHANGEOVER OF MODES)
Advertisement
