Table of Contents
Advertisement
D. Check Parts
Verify contents to ensure you have received all parts. You
should have the following:
Models
•
Unvented gas log burner assembly
•
One (1) bag of crushed volcanic rock
•
Installation/operating instructions
•
Two (2) anchoring brackets
•
Two (2) anchoring screws
•
Two (2) sheet metal screws
•
Refractory logs (packaged and sold separately)
•
One (1) bag of rock wool
•
Hand-held remote with receiver (MV) and wire
harness
Carefully inspect the contents for shipping damage. If any
parts are missing or damaged, immediately inform the
dealer from whom you purchased the appliance. Do not
attempt to install any part of the appliance unless you
have all parts in good condition.
E. Installation Information
WARNING
This appliance is for installation only in a solid-fuel
burning masonry or UL127 factory-built fireplace
or in listed ventless firebox enclosure. It has been
design certified for these installations.
Exception: DO NOT install this appliance in a factory-
built fireplace that includes instructions stating
it has not been tested or should not be used with
unvented gas logs.
Use manufacturer's installation and clearance require-
ments as defined in their manual.
The Mojo series unvented room heaters are approved for
installation into the following unvented fireboxes: MCUF,
LCUF, GCUF, GRUF, BUF and Exacta.
The Mojo Series unvented room heaters may also be
installed into a Ventless Firebox Enclosure for Gas Fired
Decorative Type Unvented Room Heaters per ANSI Z21.91
(typically referred to as a "universal firebox"), as long as
firebox hearth dimensions meet the minimum hearth dimen-
sions shown in Figure 2.1.
6
Monessen • Mojo Installation/Owner's Manual • 4614-900 Rev. C • 01/19
D
A
Dimensions for Engine & Logs
Model
MJ22 with LOGS
MJ27 with LOGS
Firebox Dimension Requirements
Model
MJ22
MJ27
Figure 2.1 - Dimensions for Engine, Logs & Firebox
C
B
A
B
C
D
23½"
13"
17"
15½"
28"
14"
21½"
15½"
A
B
C
D
27"
14"
20"
20"
31"
14"
24"
21"
Advertisement
Table of Contents
