Warranty LIMITED LIFETIME WARRANTY WHAT IS COVERED If this product fails due to a defect in materials or workmanship at any time during the first THREE years of ownership, the manufacturer will replace it free of charge, postage-paid at their option. This warranty does not cover products that have been abused, altered, damaged, misused, cut or worn.
Pre-Installation TYPICAL INSTALLATION The ducting from this fan to the outside of the building has a strong effect on the air flow, noise and energy use of the fan. Use the Roof shortest, straightest duct routing possible for best performance, Rook cap and avoid installing the fan with smaller ducts than recommended.
Pre-Installation (Continued) WIRING DIAGRAMS WIRING INSTRUCTIONS To be sold only with installation instructions. WARNING: Wiring must comply with all applicable electrical codes. Turn OFF power before removing or installing connectors. WARNING: USE COPPER TO COPPER ONLY. Do not use aluminum wire. CAUTION: The accessory part (wire nut) should meet the installation instructions below.
Pre-Installation (continued) PLANNING INSTALLATION Before beginning the product installation, make sure all parts are present. Compare parts with the package contents list and hardware contents. If any part is missing or damaged, do not attempt to install the product. 1. Carefully remove the unit from the carton. WARNING: Turn off the electricity at breaker box before 2.
Installation - New Construction CAUTION: Make sure the power is switched off at the service panel before starting installation. NOTE: Ceiling mount only. Attaching the fan housing to the Attaching the fan housing to the ceiling joist ceiling joist using suspension brackets CAUTION: Allow for the thickness of ceiling board used in your application.
Page 9
Installation - New Construction (continued) Removing the wiring cover on the fan Connecting the duct housing □ Connect a 4 in. circular duct (not supplied) and vent to the □ Remove the wiring box cover (1). Pull the house wires outside.
Installation - Existing Construction CAUTION: Make sure the power is switched off at the service panel before starting installation. Removing the existing fan Measuring the ceiling opening □ Remove the old fan from the ceiling. □ Measure the opening to ensure it is large enough to accommodate the new fan body (A) (9.25 in.
Page 11
Installation - Existing Construction (Continued) Removing the duct Removing the junction box □ Loosen the one machine screw (BB) from the housing (A) □ Remove the junction box (1) from the housing (A) by and remove the duct connector (1). loosening and removing the machine screw (BB).
Page 12
Installation - Existing Construction (Continued) Reinstalling the junction box Connecting the duct □ Reinstall the junction box (1) into the housing using the □ Using duct tape or a hose clamp (not included), attach the previously removed screw (BB). 4 in. circular duct (not included) to the duct connector (1). □...
Care and Maintenance WARNING: Disconnect the power supply before servicing. □ See SAFETY INFORMATION before proceeding. Routine maintenance should be done at least once a year. □ Never use solvents, thinner or harsh chemicals for cleaning the fan. □ Do not allow water to enter the motor. □...
Need help?
Do you have a question about the BV-BF-02-PLUS and is the answer not in the manual?
Questions and answers