Configuration & Setting; Reset To Default For Alm-Horn-Wf(-Br) Only - ICP DAS USA ALM-Horn Series User Manual

ALM-Horn Series User's Manual
2.2 Configuration & Setting
Reset to default
Dip Switch
Figure 2-5: Switches on the PCB

2.2.1 Reset to default for ALM-Horn-WF(-BR) only

Remove the back panel, Press & hold the Reset button on the side
bottom
over 6 Sec until the Red LED(Status/Alarm) quick flash then release to restore
device default setting. Default is set in AP mode.
ALM-Horn Series
User's Manual (Rev1.0, NOV/2020) ------------- 10