BEGA 84 551 Installation And Technical Information

BEGA
Installation and Technical Information
Tools Required:
• 6mm hex head screwdriver
Overview:
LED Watts: 176.0W
System Watts: 197.0W
Controllability: DMX and RDM compatible
Weight: 46.7 lbs.
Protection Class: IP67
Notice to Installer:
1. See page 2 for specific product safety warnings.
2. Suitable for operation in ambient temperatures not to exceed 45°C.
3. Floodlight must be connected to a DMX compatible lighting control system, floodlight
will not operate otherwise.
4. Installer should be familiar with "Recommended Practice for DMX 512".
5. A terminator must be used at the end of the run between data lines per the
"Recommended Practice for DMX 512".
6. It is recommended to avoid running DMX cables in parallel with power cables and
dimming cables. Failure to do so could cause interference with DMX controls.
7. BEGA luminaires may be damaged if connected to conduit systems containing water
- Article 300-5g of the National Electric Code requires that "Conduits or raceways
through which moisture may contact energized live parts shall be sealed or plugged
at either or both ends".
8. Floodlight is provided with mounting yoke that is compatible with various BEGA
mounting accessories, see specification sheet for details.
9. Floodlight is provided with 5ft of shielded 22 AWG, 2 conductor DMX cable, OD
.281".
10. Floodlight is provided with 5ft of 18 AWG, 3 conductor SJTOW supply power cable,
OD .310".
Luminaire 84551 installation:
1. Install the floodlight using the appropriate BEGA mounting accessory, or mount the
stainless steel yoke directly to a surface capable of providing suitable anchorage for
the weight of the fixture, using hardware by others. Mounting holes provided with the
yoke, see Figure 1.
2. A seperate, wet location wiring box must be supplied (by others). A U.L. listed water
tight compression fitting must be used to accept the cord from the fixture. See notice
to installer steps 9 and 10 for cord information. Note that DMX and supply wiring
connections cannot be made in the same compartment and must be separated to
prevent interference with the DMX controls.
3. Make DMX cable connections per "Recommended Practice for DMX 512":
"DMX SHIELD" : BARE WIRE
"DMX -" [NEGATIVE] : BLUE WIRE
"DMX +" [POSITIVE] : WHITE WIRE
4. Make suppy wiring and cable connections inside junction box:
MAIN VOLTAGE SUPPLY WIRE TO BLACK LUMINAIRE WIRE;
NEUTRAL (COMMON) SUPPLY WIRE TO WHITE LUMINAIRE WIRE
GREEN (GROUND) WIRE TO GREEN LUMINAIRE WIRE
5. Floodlight is vertically adjustable between -10° and +170°. To adjust floodlight aiming
angle, loosen (2) 6mm hex head screws on either side of the yoke where it attaches
to the floodlight. Aim the floodlight as desired and then tighten the (2) 6mm hex head
screws to lock into place.
Luminaire Accessories
Please refer to the appropriate accessory installation
sheet for further instruction when applicable.
Concentric ring louver
180° glare shield
360° glare shield
BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2021
Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com
Mounting Accessories
Please refer to the appropriate accessory installation
sheet for further instruction when applicable.
71 105 Mounting bracket for pole top Ø 3"
71 101 Pole mount hub for pole top Ø 3"
79 509 Pole mount canopy for 5" OD pole
Pole mount arm for 5" OD pole
Wall mount canopy
Wall mount arm
Pole top for 2 floodlights
Pole top for 3 floodlights
Pole top for 4 floodlights
Cross beam for 3 floodlights
Cross beam for 6 floodlights
Large-scale floodlight - RGBW narrow beam
A C
B
Figure 1:
8 7
Figure 2:
F
E
"DMX+" ON BLACK WIRE "DMX+" ON BLACK WIRE
"DMX -" ON BLUE WIRE "DMX -" ON BLUE WIRE
"DMX SHIELD" ON BARE WIRE "DMX SHIELD" ON BARE WIRE
INCOMING 5 FT. OF DMX CABLE INCOMING 5 FT. OF DMX CABLE
INTO THE FIXTURE INTO THE FIXTURE
D
C
INCOMING 5 FT. OF POWER CABLE INCOMING 5 FT. OF POWER CABLE
INTO THE FIXTURE INTO THE FIXTURE
B
Figure 3:
A
8 7
19 1 "
2
79 435
79 555
79 553
3 "
1
8
7 7 "
8 79 550
13 1 "
8
79 554
MOUNTING DETAIL
79 551
70 762
70 763
70 764
70 761
70 765
Dimensions
A: 19-1/2"
B: 20-3/4"
C: 12-1/8"
19 1 "
2
3 "
1
8
7 7 "
8
6 5 4
13 "
1
8
REV. CHANGED BY
MOUNTING DETAIL
WIRING FOR INCOMING DMX AND POWER INTO THE FIXTURE
DMX WIRES FROM DRIVER 1
DMX (+) (BLACK)
DMX (-) (BLUE)
DMX WIRES FROM DRIVER 2
WAGO CONNECTORS WAGO CONNECTORS
DMX SHIELD
WAGO CONNECTORS WAGO CONNECTORS
LINE (BLACK) LINE (BLACK)
NEUTRAL (WHITE)
GROUND
BEGA
ALL DIMENSIONS ARE IN INCHES
UNLESS OTHERWISE SPECIFIED:
TOLERANCES:
FRACTIONAL
ANGULAR: MACH
XX =
XXX =
6 5 4
20 "
3
4
10°
12 1 "
8
Maintenance:
Clean regularly with solvent-free cleaner
removing dirt and debris. Do not use high
pressure cleaners.
"
1
2
"
3
8
"
7
8
Replacement Parts
See label inside of fixture for LED replacement
part number.
Consult factory for all other replacement
components.
84 551
20 "
3
4
10°
12 1 "
8
"
1
2
"
3
8
7 "
8
3 2 1
REVISIONS
DESCRIPTION DATE
F
DMX + (WHITE WIRE)
DMX - (BLUE WIRE)
E
DMX SHIELD (BLACK WIRE)
DMX + (WHITE WIRE)
DMX - (BLUE WIRE)
DMX SHIELD (BLACK WIRE)
D
POWER WIRES (US5010, US5016)
FROM DRIVER 1
C
POWER WIRES (US5010, US5016)
FROM DRIVER 2
B
REV CHANGED BY DESCRIPTION
1000 BEGA Way Phone: (805) 684-0533
Carpinteria, CA. 93013 FAX: (805) 684-6682
APPROVED: DATE:
A
TITLE:
MATERIAL PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
BEGA U.S.
BEND
ANY REPRODUCTION IN PART SIZE DWG. NO. REV
OR AS A WHOLE WITHOUT THE WRITTEN C
FINISH
PERMISSION OF BEGA U.S. IS PROHIBITED. RGBW large floods wiring
DO NOT SCALE DRAWING DRAWN SCALE: 2:1 WEIGHT: SHEET 1 OF 1
3 2 1
170°
1000 BEGA Way, Carpinteria, California 93013 P (805) 684-0533 -
APPROVED: DATE: DESCRIPTION: LARGE SCAL
RGBW NARR
TYPE:
SIZE PART NO.
PROPRIETARY AND CONFIDENTIAL
84551
B
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY
OF BEGA NORTH AMERICA, INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
NOT TO SCALE 4/29/21
PERMISSION OF BEGA NORTH AMERICA, INC. IS PROHIBITED.
Updated: 04/29/21
84 551 1 of 2