Advertisement
OPERATION
Applying the LED Backlight Kit
1.
Clean and dry the surface you intend to stick the LED strips to.
2.
Remove the backing strip from the 3M adhesive tape.
3.
Press and hold the LED strip firmly against the surface.
4.
Remove the tab from the battery compartment of the remote control.
5.
Connect the USB cable to a USB port or 5V USB power adapter similar.
Changing the Remote Control Battery
1.
The battery compartment is located on the narrow side of the remote control. Pull
out the battery tray as shown (Figure 1).
2.
Remove the old battery and insert a new 3V CR2025 battery. Ensure the positive
terminal is pointing upwards.
3.
Insert the battery tray while pushing the tab until it lock firmly in place back into the
battery compartment.
Using the LED Backlights
WARNING:
Do not look directly into the LEDs as this may cause damage
to your eyes.
1.
Press the ON button on the remote control to turn the LED lights on.
2.
Select the desired colour or the desired effect and push the corresponding button
on the remote control. The colour settings are mixed colours. For this reason, the
colour tints may exhibit minor deviations.
3.
Use the Brightness control buttons to increase or decrease the intensity of LEDs.
4.
Press the OFF button to turn off the LED backlights.
CR2025
1. Pull
2. Push
Figure 1
Advertisement
