Electric, 2200 psi max pressure at initial discharge per csa internal pressure testing, 1.65 gpm max flow with nozzle open at minimum pressure (21 pages)
Page 1
, LLC ® Form No. SJ-SPX3000-RM-880E-MR1 THANKS YOUR PURCHASE OF A REMANUFACTURED PRODUCT. To make sure you get the most out of your product, be sure to register online at snowjoe.com to enjoy full product support. PASTE UPC LABEL HERE...
® ® ® When using the pressure washer, basic service center at 1-866-SNOWJOE (1-866-766-9563). safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. These include: WARNING! Do not use this appliance without reading this instruction manual.
® ® also be marked on the appliance. 1-866-SNOWJOE (1-866-766-9563). 3. Ground fault circuit interrupter (GFCI) protection – A • Keep the machine on a stable, flat surface during operation, GFCI should be provided on the circuit(s) or outlet(s) to be handling, transportation, and storage.
Risk of Electrocution plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not modify the appliance • Inspect cord before using. plug, power cord receptacle, or power cord plug in any way. • Do not use if cord is damaged. •...
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand, and follow all instructions in the WARNING! Electrical shock hazard.
Know Your Electric Pressure Washer Read the owner’s manual and safety instructions carefully before operating the electric pressure washer. Compare the illustration below to the electric pressure washer in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
+ Sun Joe customer service center at ® ® 1-866-SNOWJOE (1-866-766-9563). NOTE: Do not discard the shipping carton and packaging material until you are ready to use your new electric pressure washer. The packaging is made of recyclable materials. Properly dispose of these materials in accordance with local regulations.
Page 8
5. Insert the detergent bottles (top end first) under the ridge 6. Connect the PVC detergent tube to the detergent of their designated storage compartment (Figs. 4 & 5). connection (Fig. 7). Then snap the bottom of the bottles into the V-shaped grooves to secure them in place (Fig.
Page 9
8. To assemble the hose holder, slide the holder into position 9. Fit the spray wand into the trigger gun and rotate it until (Figs. 10 & 11) and secure it to the unit with the remaining the two parts are completely locked (Fig. 13). small screw (Fig.
Page 10
WARNING! Keep hose away from sharp objects. Fig. 18 Bursting hoses may cause injury. Examine hoses regularly and replace if damaged. Do not attempt to mend a damaged hose. 12. Connect the garden hose adapter (female coupler) to the water inlet of the pressure washer, then thread your garden hose (male end) into the garden hose adapter (Fig.
2. Engage the safety lock on the trigger handle by pushing Fig. 20 up on the safety lock until it clicks into the slot (Fig. 22). Slot Fig. 22 Slot Safety lock Trigger Safety lock 3. Turn the switch to the ON (I) position to start the pressure 3.
Page 12
WARNING! Use only detergents specifically designed Fig. 25 for use with pressure washers. DO NOT USE household detergents, acids, alkaline solutions, bleaches, solvents, flammable material, or industrial grade solutions. These could damage the pressure washer. Many detergents may require Detergent selection dial mixing prior to use.
5. Select the right nozzle for the job (Fig. 26): IMPORTANT! NEVER USE: • Bleach, chlorine products, and other corrosive chemicals Fig. 26 • Liquids containing solvents (e.g. paint thinners, gasoline, oils) • Tri-sodium phosphate products • Ammonia products • Acid-based products These chemicals will harm the unit and will damage the cleaning surface.
Page 14
Winterizing + Long-Term Storage Fig. 28 If you must store your pressure washer in a location where the temperature falls below 32ºF (0ºC), you can minimize the chance of damage to your machine by utilizing the following procedure: Pre-filter • Disconnect all water connections. •...
Snow Joe + Sun Joe ® ® customer service center at 1-866-SNOWJOE (1-866-766-9563). Model + Serial Numbers When contacting the company, reordering parts, or arranging service from an authorized dealer, you will need to provide the model and serial numbers, which can be found on the decal located on the housing of the unit.
• Pump seals worn out. • Please call the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563) for assistance. Machine stops • Fuse has blown. • Replace fuse. Switch off other machines using • Incorrect mains voltage.
Page 17
NOTE: Accessories are subject to change without any obligation on the part of Snow Joe + Sun Joe to provide notice of such ® ® changes. Accessories can be ordered online at snowjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ®...
Page 18
We’re here to help Monday through Friday from 9AM to 6PM EST. You can reach us at 1-866-SNOWJOE (1-866-766-9563), online EXCLUSIONS: at snowjoe.com, via email at help@snowjoe.com or tweet us • Wearing parts like belts, augers, chains and tines are @snowjoe.
Page 19
WARNING! This product or its power cord contains chemicals, including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information go to www.P65Warnings.ca.gov. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known [to the State of California] to cause cancer, birth defects, or other reproductive harm.
Need help?
Do you have a question about the sunjoe SPX3000-RM and is the answer not in the manual?
Questions and answers