Advertisement
INSTALLATION
Curtain Installation
Top Mounting
Rail
2. Slide the free end of the curtain into the side panel of the
air conditioner. Do this for each side. The flange for securing
the curtain into the window sill will be facing the room side
when installed (Fig.9).
Curtain
3. Fasten the curtains to the unit with short screws (Fig.10).
Fig. 10
Weather Insulation Board Installation
NOTE: The Weather Insulation Board adds an extra layer
of insulation to keep air from passing through the sides of
the window air conditioner.
1.
Using a sharp blade or scissors, slowly cut the
Weather Insulation Board to a size that will fit inside
of the side curtain rails and completely cover the cur-
tain.
2.
Once properly sized, remove the backing to expose
the adhesive tape.
3.
Place the Weather Insulation Board over the left cur-
tain and firmly press and hold for 5 seconds.
4.
Repeat above steps to install the Weather Insulation
Board on right curtain (Fig.11).
1. Attach the top mounting rail to
the unit with short screws (Fig.8).
Fig. 8
Curtain
Fig. 9
Weather Insulation Boards
Place the Cabinet Inside the Window
1.
Set the cabinet in the window so that is centered.
Place the unit so that front edge of the bottom rail
is against the back edge of the sill.
Bring the window down so that the front edge of
2.
the top rail is in front of the window. Be sure the
unit is tilting slightly to the outside.
Window
Frame
Top Rail
Bottom Rail
3. Fasten cabinet to window sill using three long
screws. Pre-drill holes if needed. Add the bottom
rail seal over the screws (Fig. 12).
Bottom Rail Seal
Fig. 12
Fig. 11
1/4"
Long Screw
Advertisement
