Watching - Panasonic TX-551000B Operating Instructions Manual

Set up the network connection
[Satellite Antenna Setup]
Ensure the satellite connections are completed
(p. 13) and select the tuner mode ([Dual Tuner] /
[Single Tuner]).
Select your region
Auto Setup is now complete and the
TV is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
Note
The TV goes into Standby mode when no operation
is performed for 4 hours if [Auto Standby] in the Timer
Menu is set to [On].
The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu
is set to [On].
To retune all channels
[Auto Setup] in [Tuning Menu] (Setup Menu)
To add the available TV signal mode later
[Add TV Signal] in [Tuning Menu] (Setup Menu)
To initialise all settings
[Shipping Condition] in [System Menu] (Setup
Menu)
22
English
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
Mains power On / Off switch should be on.
(p. 21)
2
Select the mode
TV Selection
Freeview
Satellite
Selectable modes vary depending on the stored
channels and selected country.
3
Select a channel
up
down
or
DVB and Satellite channel position begin from
number 1 upward. Analogue channel position
numbers are in the 0 - 99 range.