Care And Maintenance; Operation - Kobra AF.2 COMPACTOR Operating Instructions Manual

CARE AND MAINTENANCE

The KOBRA AF.1, KOBRA AF.2 COMPACTOR and KOBRA
AF + 1 models are high quality shredders, designed for
automatic and manual shredding.
For KOBRA AF.1 C4, KOBRA AF.2 and KOBRA AF + 1
C4 models lubrication of cutting blades with oil is
not required. However, to maintain your shredder in
optimum condition, you must use it responsibly and
periodic maintenance is recommended.
The Kobra AF.1 C2 is fitted with a special integrated
oiling system, the "AUTOMATIC OILER" which eliminates
the need for oiling the cutting knives manually so it is
advisable to periodically check the level of the oil in the
container inside the cabinet.
It is not normally necessary to operate the machine at
maximum capacity every time it is used.
It is always recommended to use the machine at less
than maximum capacity.
This will mean you need less frequent maintenance
and will prolong the life of mechanical parts.
ATTENTION!
In case of slippage or failure to pull the paper through
the machine, the 8 inlet belts in the feeder tray should
be cleaned regularly with a soft damp cloth.
AUTOMATIC OILER
ONLY FOR THE MODEL KOBRA AF.1 C2 (FIG.2)
The Kobra AF.1 C2 is fitted with a special integrated
oiling system, the
eliminates the need for oiling the cutting knives,
Kobra AF.1 C2 models come fitted with an oil container
with a capacity of 1 litre.
INSTALLATION (FIG.2)
Once you have taken the machine out of its packaging,
position the head of the machine (A) on the cabinet (B)
and insert the end of the hose (M) into the connector
(N).
Take the container of oil which came with the machine,
unscrew the cap seal and dispose of it, insert the tube
of oil (O) and screw the cap back on properly.

OPERATION:

When you have plugged the machine in, turn the knob
(H) to the position "I". The light (G) will come on for
a few seconds and the machine will start a shredding
cycle.
During the first few minutes of operation, the cutting
knives might NOT be properly oiled since the oil feeder
is not yet completely full. In order to make it fill up
more quickly, trigger the photo cells inside the mouth
so that the shredder runs empty for 8/10 minutes
straight.
Now your shredder is ready for operation and the
cutting knives are oiled.
"AUTOMATIC OILER"
It is recommended to periodically check the level of oil
in the container inside the cabinet.
REPLACING THE OIL CONTAINER
Open the door. Take out the empty oil container (P)
out of its housing, unscrew the cap on the top (Q)
and extract the oil tube (O). Get a new oil container,
remove the seal cap and dispose of it, insert the oil
tube (O) and screw the cap on tightly. Put the new oil
container back in its housing and close the door. Now
your shredder is ready for operation.
ATTENTION!
During the first few minutes of operation, the cutting
knives might NOT be properly oiled since the oil feeder
is not yet completely full. In order to make it fill up
more quickly, trigger the photo cells inside the mouth
so that the shredder runs empty for 8/10 minutes
straight. Now your shredder is ready for operation and
the cutting knives are oiled.
Fire hazard
NEVER use synthetic oil, benzene based products or
aerosol lubricants of any kind inside or in the vicinity
of the machine
COMBINATION SAFETY LOCK
ONLY FOR KOBRA AF.1 AND AF.2 COMPACTOR
MODELS (FIG. 4)
The Kobra AF.1 and Kobra AF.2 COMPACTOR models
which
can be equipped – upon request - with a combination
safety lock on the top cover of the paper feed tray to
ensure the security of documents during shredding.
COVER BLOCK FUNCTION:
Open the top cover of the paper feeder tray as shown
in figure 3. Insert the documents to be shredded into
the paper feeder tray. Close the top cover of the paper
feeder tray and the machine automatically starts
shredding. Key in the four-digit PIN number on the
keyboard (B), for example:
and the cover blocks automatically.
The top cover of the shredder unblocks automatically
when:
- the four-digit PIN number is entered.
- The shred cycle has been completed.
Important: If you forget the PIN number, the top
cover will unblock automatically 20 minutes after it
goes on stand-by.
9
ACCESSORIES
KOBRA AF+1 • AF.1 • AF.2