JVC TH-S430B-S User Manual page 18

PROBLEM/TROUBLE
Another input source is selected.
The mute function is activated.
The volume of sound bar or TV/other device
is adjusted too low.
The power cable of the unit is not
connected properly.
There is no sound
output from sound Input jacks on a playback device are connected.
bar.
Signals that the sound bar cannot playback
when being input.
The sound is distorted
TV volume is not muted.
or echoed.
The automatic volume adjustment function is
The volume decreases
activated. To prevent excessive loudness, the
when the unit is turned
unit automatically controlls its volume within
on.
a certain level when the unit is turned on.
The sound bar is too close to another
Noise is heard.
digital or high-frequency device.
The unit is out of the operating range.
The unit cannot be
The batteries are weak.
operated by using
the remote control.
The remote control sensor of the sound bar
is exposed to direct sunlight or strong lighting.
The TV cannot be
The unit is blocking the TV's remote
operated by using the
control sensor.
TV's remote control.
Bluetooth function of the device is not activated,
not paired or connected correctly.
Bluetooth is not selected as the input source.
The unit is connected to a different Bluetooth
device.
A device cannot
connect the sound
The unit is too far away from the Bluetooth device.
bar or the unit cannot
be connected to a
A device emitting electromagnetic waves
Bluetooth device.
(such as a microwave oven, a wireless
device and so on) may be placed nearby.
The Bluetooth device that you are using
may not support the protocol.
The connection profile registered in the
Bluetooth device may not be functioning
correctly for some reason.
POSSIBLE CAUSE
15
SOLUTION
Select an appropriate input source.
Cancel the mute function.
Increase the volume level on sound bar or
by remote control or on TV.
Make sure that the power cable of the unit is
connected to an AC wall outlet securely.
Connect the input jack on the sound bar and
the output jack on the playback device.
When sound bar and TV or other devices are
connected by an audio cable through TV (ARC)
port output, Select the correct audio input and
output. Make sure the digital audio output setting
on the playback device to PCM format. Since the
output format of our sound bar is PCM, if it is used,
the decoding format of TV or other devices will be
adjusted to PCM state.
If you play audio from TV through the sound bar,
make sure that the TV is muted.
Turn up the volume as required.
Move those devices away from the sound bar.
Use the remote control within the operating range.
Replace with new batteries.
Adjust the lighting angle or reposition the sound bar.
Make sure our product cannot be used in sunlight.
Position the unit so that it does not obstruct the TV's
remote control sensor.
Restart the sound bar and try pairing again. You have
not enabled the Bluetooth function of the device; see
the user manual of the device on how to enable the
function and correctly connected the device. The sound
bar is already connected with another Bluetooth device.
Disconnect the connected device, and then try again.
Select Bluetooth as the input source.
Un-pair the Bluetooth device that is currently connected
and pair with the desired Bluetooth device.
Move the Bluetooth device closer to this unit.
Do not use this unit near devices that emit
electromagnetic waves.
Use a Bluetooth device that supports the protocol.
Delete the connection profile in the Bluetooth
device and then connect the Bluetooth device to
this unit.