Advertisement
Installation (continued)
3
Remove the
mounting base plate
NOTE: The mounting plate tightening screws
(C) comes pre-installed on the light fixture.
☐
Loosen the two mounting base
tightening screws (C) using a philips
screwdriver and remove the refractor.
(Fig. 1)
☐
Remove the reflector from the base
plate (D) by loosening the two small
screws. (Fig. 2)
CAUTION: DO NOT touch the LED and Photo-
cell lens (E) inside the fixture. DO NOT damage
or soil the reflector.
4
Knock out holes on
mounting base
☐
Measure the distance of the mounting
threaded holes on the junction box and
find the corresponding knock-out holes
in the fixture's mounting base (D).
☐
Use a flat head hammer and screw
driver to knock out two holes in the
mounting base (D) in the desired
location to align properly with the
junction box. (Fig. 1)
Visit www.probrite.com/install for installation video tutorials and product support
E
(fig 1).
C
Reflector
Small screws
(fig 2).
D
(fig 1).
6
Installation (continued)
5
Installing the mounting base
D
Junction box Mount
☐
Route the junction box wires through
the large center hole in the mounting
base (D).
☐
Align the holes on the mounting
base (D) with the holes on your
D
junction box. Use two #8 screws (AA),
depending on the size of the holes in
your junction box, attach the mounting
base (D) to your junction box. (Fig. 1)
Surface Conduit Mount
☐
Mark and drill two holes on the wall
surface as per the desired location for
fixing the mounting plate (D).
☐
Use two or more suitable screws
(provided by others) applicable to
the surface of mounting and fix the
mounting plate (D) on the surface.
(Fig. 2)
6
Making the electrical
connections
Junction box Mount
☐
Follow the wiring instructions
given below to make the electrical
connections. (Fig. 1)
AA
Screws
(Provided by others)
7
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
D
(fig 1).
D
(fig 2).
(fig 1).
PROBRITE.COM
Advertisement
