Maintenance - Husqvarna R 214T Operator's Manual

6. Press the lock button on the lift lever for the cutting
deck and lower it to mow position.
To stop the engine
1. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck. The blades
stop to rotate.
2. Turn the ignition key to the STOP position.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
1. PREPARE THE PRODUCT
Do a check of the battery.
Do a check of the blades.
Do a check of and clean hydraulic hoses and couplings. Replace if necessary.
1686 - 001 - 03.11.2021

Maintenance

Before you do any
3. When the product stops, apply the parking brake.
To apply and release the parking brake
1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
1
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
15 .
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, refer to
page 31 ). Move the product forward at low speed. If
the grass is not too high and thick, you can get a
good cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the function.
Maintenance schedule
First
servicing
2
Technical data on
Maintenance interval
in hours
50 100 200
O
O
O
15