CAUTION : The laser used in the Super Multi DVD Rewriter can damage your eyes. Do not attempt to open the cover. To reduce the risk of electric shock, do not remove the cover (or back). There are no user-serviceable parts inside. Refer servicing to qualified service personnel.
This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 2004/108/EC, 93/68/EEC and 2006/95/EC. CAUTION : CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO THE BEAM. ADVARSEL : KLASSE 3B SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING.
Software Required OS Windows 2000 Professional/XP(Home Edition/ Professional)/Vista, Direct X 9.0 or Higher is required CD-R, CD-RW, CD-R : LG, Mitsubishi Kagaku Media, Verbatim, That’s, Ritek or HP discs DVD-R, DVD-RW, are recommended. DVD+R, DVD+RW, CD-RW : LG, Mitsubishi Kagaku Media, Verbatim are recommended.
❏ Occasionally CD-R and CD-RW discs written by a CD-R/RW drive cannot be read by other CD drives*. These unreadable discs may need to be read using the CD-R/RW drive they were created with The disc written using the CD-R/RW drive might not be readable by CD-ROMs other than Multi-read compatible (UDF compatible) CD-ROMs Multiread compatible (UDF compatible) CD-ROMs are: 1.
Installing the Drive Before installing the drive, please note the following points. ■ You will need the following: • A screw driver of a suitable size to fit the securing screws for the drive unit. • The manual for the computer, so you can find the mounting positions for the IDE controller cable.
NOTE : Only one jumper should be installed on the jumper connector. If more than one jumper is installed, the drive may malfunction or be damaged. Master/Slave setting is determined by jumper installation on the Jumper Connector. The following table shows the possible jumper settings. Name Function Drive set as Master...
To Install as a Slave Drive To install the drive as a Slave, change the jumper setting on the rear panel to SL. Master drive (Booting hard disk) Slave drive - OR - (Super Multi DVD Rewriter) (Jumper set to Slave) connector Connecting the Power Connector...
Device Drivers When using Windows 2000 Professional/XP Home Edition/XP Professional/Vista, no special device driver is required. Your system, upon Power On and bootup after installing and connecting the new Super Multi DVD Rewriter, will recognize and load native software drivers automatically. Please consult the following internet sites: http://www.lgservice.com (then choose your country from the list) For Windows 2000/XP/Vista Users...
How to Use the Discs When using CD-ROM discs, CD-R discs, DVD discs or CD-RW discs, don’t attach any stickers or labels to the discs. It could cause read and write errors, but data on the disc may be lost due to damage to the disc itself. The Discs in this unit operate at a very high speed! DO NOT use damaged, cracked or warped discs.
Troubleshooting Before Requesting Service Before calling for service, check this list. The drive doesn’t have power. • • Is the power supply cable from the host computer plugged in? • Is the Power Connector to the drive securely attached? The system doesn’t start. •...
Rua Vítor Câmara, nº2, Piso 2 2700-229 Paço d´ Arcos, Portugal ou www.lge.pt Please visit www.lgservice.com and install the program, “LG ODD Online F/W update.” By using the program, you can automatically check the latest information about FirmWares and update the FirmWare. P/NO. 3828HM1057U Ver.