Samsung AC180JNHPKH/AR Service Manual page 66

Setting an indoor unit address and installation option
Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and
follow the directions below.
1) Press the and
displayed.
2) Press the / button to select
3) Press the / button to select
code setting screen.
• The first digit represents the page number and the remaining five digits are installation option.
NOTE • The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
4) Press the / button to set the installation option code in order. Press
page.
SEG1 SEG2
0 2
SEG7 SEG8
1 Drain pump
SEG13 SEG14
2 External control
SEG19 SEG20
Individual control of
3
a remote controller
Samsung Electronics
buttons at the same time for more than 3 seconds and then a Main menu will be
and then press
and then press
SEG3
RESERVED
SEG9
Use of Hot Coil
SEG15
External control
output
SEG21
Heating setting
compensation
button to enter a Sub-menu setting screen.
button to enter a Indoor unit installation option
SEG4
Exterior
Central control
temperature sensor
SEG10
RESERVED RESERVED
SEG16
S-Plasma ion
SEG22
RESERVED Away Set OFF Timer
button to go to the next
SEG5 SEG6
RESERVED
SEG11 SEG12
Master / Slave
SEG17 SEG18
Number of hours
Buzzer
using filter
SEG23 -
-
4-33