Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS PLEASE READ CAREFULLY
Model No.
1000 Series
1000T Series
1. The concrete base should be 6" thick x 14" longer than enclosure ID x 14" wider than enclosure ID.
A. Mark the concrete base for the outside of the enclosure (3" wider than ID and 3" longer than ID).
2. The PVC masking film will help to protect the finish of the metal panels during installation. These
coatings should be left intact and removed only after assembly of the enclosure is complete.
A. Assemble the "B1-A-B2" (side-end-side) assemblies using hex headed screws. (For best results, insert a
bead of silicone caulk into the inside bend of the "A" panel corners.) Position both sets of assembled
panels on the marked concrete base (Fig 2).
The information contained herein is intended for the use of the individual(s) named above and those authorized to receive it. Dissemination, distribution
or copy of this information is strictly prohibited.
Inside
Dimensions
40"W x 144"L x 80"H
40"W x 144"L x 90"H
Outside
Dimensions
43 3/4"W x 147"L x 83 1/4"H
43 3/4"W x 147"L x 93 1/4"H
Recommended Concrete
Pad Dimensions
54"W x 158"L x 6" Thick
54"W x 158"L x 6" Thick
Advertisement
Related Manuals for Safe-t-Cover 1000 Series
Summary of Contents for Safe-t-Cover 1000 Series
- Page 1 Outside Recommended Concrete Model No. Dimensions Dimensions Pad Dimensions 1000 Series 40"W x 144"L x 80"H 43 3/4"W x 147"L x 83 1/4"H 54"W x 158"L x 6" Thick 1000T Series 40"W x 144"L x 90"H 43 3/4"W x 147"L x 93 1/4"H 54"W x 158"L x 6"...
- Page 2 NOTE: model sizes and configurations vary, see the chart. 3. Inspect the alignment of the “C” (access) panels during the assembly process. Verify that their removal and replacement allows adequate space and positioning within the openings and with the adjacent panels prior to attaching any bracket to the concrete. 4.
- Page 3 5. On the inside, place the Inner Roof Connection Bracket under the “D1-D2” 2x4 connection. Using hex headed screws, fasten the Inner Roof Connection Brackets into place (Fig. 1E). A. The Inner Roof Connection Bracket has a tab on one side. This tab will fasten to the top of the “F” post stud later.
- Page 4 Model No. 1000-AL Series Model No. 1000T-AL Series CONTENTS 1. Your assembly should include A. 2- “A” (end) Panels B. 2- “B1” (side) Panels C. 2- “B2” (side) Panels D. 2- “C” (access) Panels E. 1- “Cw/d” (access) Panel F. 1- “D1” (roof) Panel G.