IMPORTANT SAFETY INSTRUCTIONS ***WARNING*** Read all instructions before using this appliance. This vacuum cleaner is specifically designed for household purposes. Please do not use for commercial or industrial purposes. Always turn the power off at the power outlet before you remove or insert the power plug.
Page 4
Failure to do so could cause permanent damage to the Vacuum cleaner. Neither Westinghouse nor the retailer can accept any liability for damage to the product or personal injury resulting due to failure to observe the warnings and procedures included in this instruction manual.
DAMAGE PREVENTION & WARNINGS NOTE: Switch off the vacuum cleaner immediately if the air intake, the floor brush or the telescope tube becomes blocked. Before switching the vacuum cleaner on again, remove the substance causing the blockage. Never use the vacuum cleaner in the immediate vicinity of hot bodies and do not vacuum hot objects such as cigarette ends or ashes.
PREPARING THE VACUUM CLEANER Carefully unpack your cordless vacuum cleaner. Remove packaging around the vacuum cleaner, power cord and AC plug. Do not remove warning labels. Lay all components out on the floor ready for assembly. INSTALL & CHARGE OF BATTERY PACK Battery capacity indicator When the vacuum cleaner power is insufficient or the vacuum cleaner is being charged for the first...
ASSEMBLING THE VACUUM CLEANER Before assembling the vacuum cleaner, mount the included wall-mounted storage unit to the wall. Ensure it is mounted high enough to allow the vacuum cleaner to rest on the wall- mount at full height. Place the mount against the wall and using the wall unit mounting holes as a guide, mark the wall where the wall plugs (brick only) will be drilled and inserted.
OPERATION to the desired NOTE: Although suitable for light use on carpets, cordless vacuum cleaners perform best when used on hard floors. NOTE: To ensure maximum performance is maintained, regular cleaning of ush are NOTE: Running times are up to 20 minutes on MAX mode and up to 40 minutes on ECO mode.
CLEANING & CARE ARNING: Do not under any circumstances immerse the power cord, mains plug or vacuum cleaner body in water or any other liquid. WARNING: Do not attempt to clean the unit whilst it is still plugged into the electrical power outlet. Always unplug the unit before cleaning. o not use harsh or abrasive cleaning agents.
Page 11
CLEANING & CARE (CONTINUED) Cleaning power brush head and roller After extended periods of use, the power brush head and roller will require cleaning to remove hair and other foreign objects that have become tangled or stuck, preventing the vacuum cleaner from operating effectively. Regular cleaning is recommended and described in the steps below.
TROUBLESHOOTING BEFORE CALLING FOR SERVICE If the appliance fails to operate: Check to ensure the battery is fully charged. Check for a blown or tripped circuit breaker in your home. If these seem to be working correctly, test another appliance in the same outlet to ensure the outlet is working correctly.
Need help?
Do you have a question about the WHVCSV04SB and is the answer not in the manual?
Questions and answers