Subscribe to Our Youtube Channel
Related Manuals for Westinghouse VC251809
Summary of Contents for Westinghouse VC251809
-
Page 1: Instruction Manual
INSTRUCTION MANUAL WET / DRY VACUUM VC251809 Note : Read and understand this manual before use. Keep this manual for future reference. 120 V 60 Hz... - Page 2 TABLE OF CONTENTS PAGE Important Safety Instructions ....2 - 4 Extension Cords ......Assembly .
-
Page 3: Important Safety Instructions
Use this Wet/Dry Vac only as described in this manual. To reduce the risk of personal injury or damage to your Wet/Dry Vac, use only WESTINGHOUSE recommended accessories. For Household Use Only. SAVE THIS MANUAL FOR FUTURE REFERENCE. -
Page 4: Polarized Plug
• Turn off Wet/Dry Vac before unplugging. • Do not put any object into ventilation openings. Do not vacuum with any ventilation openings blocked; keep free of dust, lint, hair or anything that may • and moving parts. • To reduce the risk of falls, use extra care when cleaning on stairs. When using as blower: •... -
Page 5: Extension Cords
EXTENSION CORDS When using an extension cord with your Wet/Dry Vac refer to the following table to determine the required A.W.G. wire size. Before using the cleaner make sure the power cord and extension cord are in good working condition. Make repairs or replacements before using the vacuum cleaner. -
Page 6: Assembly
ASSEMBLY Remove entire contents of carton and check for parts inside the collection tank. Check each item against the Carton Contents List. Carton Content List Key Description Vac Assembly ... . 1 Hose Assembly. -
Page 7: Assembly
GENERAL ASSEMBLY INSTRUCTIONS A Phillips head screwdriver is required. WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC. UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY 1. Ensure that the power cord is disconnected from the power outlet. (Fig. 1) 2. -
Page 8: Operation
OPERATION VACUUMING DRY MATERIALS WARNING: Be sure to read, understand and apply all the information in the Important Safety Instructions section at the beginning of this vapors, or explosive dusts in the air. Flammable gases or vapors gasoline, alcohol, or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, grain, or gun powder. - Page 9 VACUUMING LIQUIDS WARNING: Be sure to read, understand, and apply all the information in the Important Safety Instructions section at the beginning of this vapors, or explosive dusts in the air. Flammable gases or vapors oil-base paints, gasoline, alcohol, or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, grain or gun powder.
-
Page 10: Operation
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in the liquid. Leave a gap at the tip of the nozzle opening to action when the container reaches its maximum capacity. You will notice an increase in motor speed. When this happens, turn off the machine, disconnect from power supply, and drain the liquid into a suitable receptacle or drain. -
Page 11: Maintenance
MAINTENANCE EMPTYING THE COLLECTION TANK 1. Verify that the power cord is disconnected from the outlet. (Fig. 1) 2. Disconnect the hose from the vacuum. (Fig. 2) 3. Undo the latches and remove the power head from the collection tank. (Fig. 3) Place the power head upside down on a soft, clean surface. - Page 12 the inside wall of the container or brush the dirt off. Debris will begin to break up, loosen, and fall. NOTE: outdoors and not indoors. IMPORTANT! ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is WARNING: Always disconnect the plug from the power outlet before removing the power head from the collection tank.
- Page 13 INSTALLING AND CLEANING FOAM SLEEVE FILTER Installing Foam Sleeve Filter 1. Verify that the power cord is disconnected from the outlet. (Fig. 1) as shown on page 10 “Removing and Cleaning Cartridge Filter”. whole cage is covered. (Fig. 2 & 3) 4.
-
Page 14: Troubleshooting
TROUBLESHOOTING WARNING! TO REDUCE THE RISK OF ELECTRICAL SHOCK - ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE TROUBLESHOOTING. SYMPTOM CORRECTIVE ACTION POSSIBLE CAUSES Vacuum will not 1. Check power supply - 1. No power supply. operate. cord, breakers, fuses. 2. -
Page 15: Maintenance
WARRANTY We take pride in producing a high quality, durable product. This product carries a limited two (2) year warranty against defects in workmanship and materials from date of purchase under normal household use. If product is to be used for commercial, industrial or rental use, a 90 day limited warranty will apply.
Need help?
Do you have a question about the VC251809 and is the answer not in the manual?
Questions and answers