Table of Contents
Advertisement
Drying is taking too long.
Unpleasant odour in the appli-
ance
Humidity in the room is increas-
ing.
Unusual noises when drying.
The appliance feels cold
despite drying.
Drying programme is stopped.
Residual water in the conden-
sation container despite the
appliance being connected to
the drain hose*.
* Depending on how the appliance is equipped or the available accessory
--------
If you cannot rectify the fault yourself by turning the appliance off and then on
Note:
again, please contact our after-sales service.~ Page 56
The appliance may have fluff in it. This will increase the required dry-
■
ing time.Remove the fluff.~ Page 33
The heat exchanger may have fluff in it. Run the basic appliance care
■
programme. ~ Page 45
If the air inlet on the appliance is blocked or not fully open, this may
■
increase the drying time. Make sure that the air inlet remains unob-
structed.
If the ambient temperature is lower than 15 °C or higher than 30 °C,
■
this may increase the drying time.
Inadequate air circulation in the room may increase the drying time.
■
Make sure the room is adequately ventilated.
Run the intensive appliance care programme. ~ Page 47
Make sure the room is sufficiently ventilated.
When drying is in progress, the pump and compressor generate noise
when operating normally. This does not indicate that the appliance is
malfunctioning.
Not a fault. The appliance can dry effectively at low temperatures using a
heat pump.
If the drying programme is stopped due to a power failure, restart the
programme or remove the laundry and spread it out.
If the optional drain hose is installed, residual water remains in the con-
densation container due to the appliance's self-cleaning function.
Help with the appliance
en
51
Advertisement
Table of Contents
