Mount V-Bunk Support - Golden Tornado 6-CYLINDER Installation Manual

MOUNT V-BUNK SUPPORT

Note: This step only applies to the 18K capacity Tornado Boat lift.
When assembling the 15K Capacity lift, please skip to the next
step.
1. Align the 1" holes of the H-Frame(s) with the corresponding
holes on the V-Bunk Support, resting the V-Bunk Support
on top of the H-Frame(s) as shown in Figure 14.
2. Insert one (1) 1/8" Cotter Pin into one (1) 1" Hinge Pin, bending
the tines of the Cotter Pin outward and apart, securing the
Cotter Pin within the Hinge Pin.
3. Attach a Flat Washer to the open end of the Hinge Pin.
4. Insert the Hinge Pin through the hinge plate as shown in
Figure 15.
Note: Please a Lollipop Washer between the hinge plate and the
V-Bunk Support on both sides as you slide the Hinge Pin through.
5. Insert one (1) Flat Washer and one (1) 1/8" Cotter Pin into the
protruding end of the Hinge Pin, bending the tines of the
Cotter Pin outward and apart, securing the Cotter Pin within
the Hinge Pin.
6. Repeat this step five (5) more times, twice for the other H-
Frames and three times for the other V-Bunk Support.
Figure 14
PARTS REQUIRED TO MOUNT V-BUNK
Lollipop Washer
(12)
1" x 5-3/8" Hinge Pin (6)
Figure 15
16
SUPPORT
V-BUNK SUPPORT
1/8" Cotter Pin (12)
1" Flat Washer (12)