Table of Contents
Advertisement
12
www.aeg.com
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and
blank.
2. Press
• The indicators
and
• The indicator
• The display shows the current
setting:
3. Press
= Acoustic signal on.
4. Press on/off to confirm the setting.
6.6 How to set the colour of
the TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and
blank.
2. Press
• The indicators
and
• The indicator
and
,
,
,
flash and the display is
,
,
are off.
still flashes.
= Acoustic signal off.
to change the setting.
and
,
,
,
flash and the display is
.
,
,
are off.
still flashes.
• The display shows a number and
letter C. Each number refers to a
different colour.
–
3. Press
colour.
4. Press on/off to confirm the setting.
6.7 AirDry
AirDry improves the drying results with
less energy consumption.
until
,
,
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
open. This can cause
damage to the appliance.
CAUTION!
In case of presence of
children, the AirDry system
can be deactivated if you
want to keep the door
until
closed in the end of the
,
cycle.
AirDry is automatically activated with all
programmes excluding
To improve the drying performance refer
,
to the XtraDry option or activate AirDry.
= TimeBeam
deactivated.
repeatedly to change the
Advertisement
Table of Contents
