Installation - Electrolux ERN1400AEW User Manual

8.1 Replacing the lamp
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3.
Remove the lamp cover (refer to the
illustration).
4. Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown
on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8.
Open the door. Make sure that the
lamp comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
9.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
9.3 Door reversibility
The door of the appliance opens to the
right. If you want to open the door to the
ENGLISH 23