Table of Contents
Advertisement
VIDEO
CONFIGURE VIDEO RESOLUTION
From the Konftel CC200 GUI
From the Konftel CC200 GUI
Click Configure (
Click Advanced.
•
Konftel CC200 prompts you to enter a PIN. The default PIN is 1234.
Click Calls.
Click Video Quality.
From the web interface
From the web interface
Click Administrator Settings.
Click Calls > Video Quality.
Video Quality settings
NetSense
Flow Control
TMMBR RFC5104
Lip-sync Automatic
Delay
Sharpness
Presentation Sharpness
Live Video on Presentation Yes/No.
).
NetSense dynamically scans the video stream and reduces or
improves the video resolution to maximize quality with the
available bandwidth.
Set to Yes to send a Flow Control request to the remote
endpoint in case of packet loss. It attempts to reduce the
speed of data flow to prevent overwhelming one side with
too much data.
Temporary Maximum Media Stream Bit Rate Request
(TMMBR, 'timber'), as specified in RFC 5104. This allows a
receiver, translator, or mixer uses the TMMBR to request a
sender to limit the maximum bit rate for a media stream to
or below, the provided value, without using reinvites, thus
reducing IOT issues.
Allows synchronizing audio with video. If set to Yes, the system
will perform automatic synchronization (highly recommended
setting). If set to No, adjust manually by dragging the Delay
slider until you obtain the best synchronization.
Available if Lip-sync Automatic is set to No.
Select Yes to enable more definition or video sharpness and
alter the bandwidth required to maintain a video resolution.
Select No to prefer more fluidity in motion.
Yes/No.
55
Advertisement
Table of Contents
