Advertisement
Available languages
Available languages
service agent or a similarly qualified person in order to avoid a hazard.
19.
Remove the plug from the socket before performing maintenance. Before
using the machine make sure that the frequency and voltage shown on the
rating plate correspond with the mains voltage. Specifications and details
are subject to change without prior notice. The accessories shown in the
pictures may vary from model to model.
Assembling wet& dry Vacuum Cleaner
Always remove the power plug from the wall outlet before assembling or removing
accessories.
Unpacking and set-up summary
1.
Pull lid latches in an outward motion, remove power head and some accessories
that my have been shipped in the tank.
2.
Attach the casters according to the instruction int this manual.
3.
Before replacing power head, refer to this manual to ensure you have the
HEPA filters installed for your cleaning operation.
4.
Replace power head and apply pressure with thumb to each latch until it
snaps tightly in place. Make sure all lid latches are clamped securely.
5.
Insert the flexible hose end into inlet of tank.
6.
Attached the extension wands to the accessory end of the hose. Apply slight
pressure until fitting is tight.
7.
Attached one of the cleaning accessories ( depend on your cleaning
requirements) on the extension wands. Twist slightly to tighten the connection.
8.
Plug the cord into the wall outlet. Your cleaner is ready for use.
Assembing
Assembly and disassembly of the tube
1.
Montage: Insert the tube in the air intake opening. Push the tube in until it
locks in place.
Disassembly: Take the tube from the air intake after disconnecting from the
mains socket.
INSTRUCTION FOR USE
12
Advertisement
