Introduction; Intended Use; Safety - Pentair HAFFMANS GMT Instruction Manual

2.

INTRODUCTION

2.1

Intended use

The CO Gehaltemeter is only intended to be used to determine the gas equilibrium pressure
2
and the temperature of a liquid when calculating the CO
The instructions in this manual refer to the position numbers given in the diagram in appendix
IV.
2.2

Safety

This section gives the most important instructions for the safe use of the CO
The meaning of the safety symbols are also explained.
2.2.1 Safety instructions
Read the safety instructions carefully before using the CO
instructions must be strictly observed during use.
•
The maximum permitted pressure in the CO
dangerous to allow the pressure in the CO
bar, because the Gehaltemeter may explode.
•
Make sure the pressure in the instrument does not exceed the range of the pressure
Gehaltemeter.
2.2.2 Safety symbols
Attention, warning and danger symbols used in this manual have the following significance.
Attention!
Warning
GMT
Information for correct or effective use of the equipment.
Incorrect or careless use can cause serious damage to the
equipment.
Failure to observe this information can result in major
personal injury or loss of life.
content.
2
Gehaltemeter. The safety
2
Gehaltemeter is 5 bar. It is extremely
2
Gehaltemeter to increase to more than 5
2
HAFFMANS GMT
Gehaltemeter.
2
Page 9 of 37