Table of Contents
Advertisement
How To Use The Timer
Select the timer mode by pressing the Cook / Timer button.
1.
The display will show two groups of "00:00" (Hours / Minutes). Press the Probe 1
2.
Setting button to enter the setting mode of Probe 1 timer. As the Hour digits flash,
press the Increase button to increase or the Decrease button to decrease the value
to set hour value you need.
Press the Start/Stop button to enter the setting of minutes. As the Hour digits
3.
flash, press the Increase button to increase or the Decrease button to decrease the
value to set hour value you need.
Press the Probe 2 Setting button to enter the setting mode of Probe 2 timer, with
4.
the same input method as steps 2-3.
Note: Maximum timer value is 99 hours 59 minutes.
To start the timer, press the Start/Stop button. The ":" between hours and minutes
5.
will flash to indicate that the timer is on.
6.
When the preset time is up, the Alert will sound and the timer digit will flash. Press
the Start/Stop button to stop the alarm; if not manually stopped it will continue for
one minute (60 seconds). The alarm icon will keep flashing after the alarm has
stopped beeping, until the temperature falls below the preset temperature.
To reset the timer, enter the timer setting mode and press the Increase and the
7.
Decrease buttons simultaneously.
How to Cook
Ensure the wire is connected to the Transmitter, and then insert the stainless-steel probe into
the food to be cooked.
Note: For an accurate reading of the internal temperature, insert the probe at least 3cm
(1.25 inches) into middle of the thickest part of the meat. Ensure the probe is away from any
bones and is enclosed inside the meat. Do not let the probe pass through the meat to the
outside.
Once the probe is inserted, the actual meat temperature will be displayed on the left of LCD
and will increase gradually during cooking.
The alarm will automatically beep when the probe temperature reaches the preset
temperature (ALERT TEMP), indicating the meat is cooked to the desired "Done" setting.
When the preset time is up, the Alert will sound and the timer digit will flash. Press the
Start/Stop button to stop the alarm; if not manually stopped it will continue for one minute
(60 seconds). The alarm icon will keep flashing after the alarm has stopped beeping, until
the temperature falls below the preset temperature.
Advertisement
Table of Contents
