Table of Contents
Advertisement
Installation
2
Choose a right heat pump unit
Based on the local climate condition, construction features and insulation level,
calculate the required cooling(heating) capacity per square meter.
Conclude the total capacity which will be needed by the construction.
According to the total capacity needed, choose the right model by consulting the heat.
pump features as below:
Heat pump features
Cooling only unit： chilled water outlet temp. at 5-15℃, maximum ambient temp. at 43℃.
Heating and Cooling unit： for cooling chilled water outlet temp. at 5-15℃,maximum ambient
temp. at 43℃. For heating, warm water inlet temp. at 40-50℃, minimum ambient temp. at -10℃.
Unit application
a
s
Inverter
ir
ource
heating or cooling separately, with each area need to be controlled.
3 Installation place
The unit can be installed on any place outdoor which can carry heavy machine such
as terrace, housetop, ground and so on.
The location must have good ventilation.
The place is free from heat radiation and other fire flame.
A pall is needed in winter to protect the heat pump from snow.
There must be not obstacles near the air inlet and outlet of the heat pump. A
place which is free from strong air blowing.
There must be water channel around the heat pump to drain the condensing water .
There must be enough space around the unit for maintenance.
4 Installation method
The heat pump can be installed onto the concrete basement by expansion screws, or onto
a steel frame with rubber feet which can be placed on the ground or housetop.
Make sure that the unit is placed horizontally.
w
h
p
is used for house, office, hotel, and so forth, which need
ater
eat
ump
10
Advertisement
Table of Contents
