Mounting And Dismounting Of The Mower Alpha 2000 / Alpha Sensor At The Tractor - Braun Mower Alpha 2000 Manual Instruction

4. Mounting and dismounting of the mower Alpha
1. First, install joint shaft at the mower (see assembly instruction of the joint shaft
manufacturer).
2. Carry out trimming of the joint shaft according to manufacturer's
instructions, hereby, only designcertified joint shafts with complete safety
device (protective hose, shaft guard) must be used, otherwise it will result
into immediate expiration of complete warranty and/or guarantee claim.
3. Mounting and dismounting of the joint shaft only when the motor is switched
off and the key is turned off.
4. Secure shaft guard against revolving
5. The three-point linkage of the tractor must be adapted to the mower.
6. The mower must be firmly locked in the three-point linkage (lower linkage
tensioned laterally).
7. The release ropes for quick couplings should hang freely and may not
release automatically when in lower position.
8. Lower and upper linkage bolts must be secured by linch pins.
9. Connect the center-mounted units with hydraulic width adjustment of the
Alpha 2000 / Alpha Sensor to a double acting control valve.
10. By Alpha Sensor: connect the marked hoses (black = return, red = pressure)
to a single acting spool valve including oil flow management and free
return. Please pay attention that the hydraulic couplings will lock.
11. Lay hoses frictionless and NOT next to the exhaust. Fix them flexibly with hose
clamps.
After lowering down the mower, put joint shaft and hoses in the foreseen
holding devices (see picture 3) and place the mower on level ground.
Version: 1
2000 / Alpha Sensor at the tractor
Page 5 of 16