Advertisement
Quick Links
Advertisement
Related Manuals for Flexispot 9127
Summary of Contents for Flexispot 9127
- Page 1 INSTRUCTION MANUAL MODEL:9127...
-
Page 2: Package List
PACKAGE LIST Seat Plate Gas Lift Star Base Casters Quantity:1 Quantity:1 Quantity:1 Quantity:5 Left Right Seat Cushion Back Cushion Armrests Steel Plate Quantity:1 Quantity:1 Quantity:1 Quantity:2 ② ③ ④ ① Bolts M8x20mm Bolts M6x25mm Bolts M6x30mm Bolts M8x45mm Quantity:3 Quantity:4 Quantity:4 Quantity:4 ⑤... - Page 3 ASSEMBLY INSTRUCTIONS STEP 1 : Turn the Star Base upside down, then press the Casters into the holes at the end of each base leg. STEP 2 : Turn the Star Base upright and insert the Lift into the center hole of the Star Base.
- Page 4 STEP 3:Align the seat plate to the bottom of the seat cushion, make sure that the front of the seat plate is facing the front of the seat cush ion Attach the seat plate to the seat cushion using four M6X25mm bo lts,tighten all the bolts with the T-wrench.
- Page 5 STEP 5: Turn the seat cushion upright and align the center hole of the seat plate over the lift, then push the seat cushion down onto the lift firmly until the connection is secure. STEP 6: Attach the Steel Plate to the back cushion with four M6x30mm Bolts.
- Page 6 STEP 7:Attach armrest to the connector with M8*45mm Bolts on both sides, using the T-Wrench，Then tighten all the screws ，Finally Press the plastic caps into the adjuster holes to cover the bolts. ④⑦ ⑥ STEP 8:Tighten all the screws that are not tightened. ⑦...
- Page 8 INSTRUCTIONS FOR USE 1.Seat Height:Paddle-shaped lever on the right side To raise while taking your weight off chair， lift lever up. To lower while seated,lift lever up. *At the proper height,your feet should rest flat on the floor. 2.Tilt Tension: Long stem under the seat cushion with knob To increase tension: while seated,turn knob forward (toward+sign).
- Page 9 INSTRUCTIONS FOR USE 3.Operating the tilt lockout. To let your chair tilt back,pull the control handle out. To stop your chair from tilting, sit forward,then push the control handle in. *At the proper height,your feet should rest flat on the floor. 4.Backrest Recline Pull the lever FULLY and lean back slowly until desired angle...
- Page 10 INSTRUCTIONS FOR USE 5.Relax with footrest Pull out the pole of the footrest,and turn the footrest to the front. *At the proper height,your feet should rest flat on the floor.
- Page 12 promises to repair or replace any chair that is found to be defective in material or workmanship within one (1) and year from the date of orig inal purchase so long as you,the original purchaser,still owns it. This is your sole and exclusive remedy.This warranty is subject to the provisio ns below...