Riverside Furniture Corinne Assembly Instructions

Riverside
email: info@riverside-furniture.com
1 pc.
2 pcs.
Curved Washer
32 L x 13 x 8mm
8 pcs.
ASSEMBLY STEPS :
To prevent possible damage to furniture and personal injury, it is recommended that two people are used to
perform the following steps.
5. Install two All-Thread Bolts (R-B) into the metal threaded inserts installed in the Headboard Legs and into
the metal inserts on the Footboard.
6. Carefully position one end of one Bed Rail (R-A) onto the All-thread Bolts on the Headboard and connect
using the Curved Washers (R-E), Spring Washers (R-D), and Hex Nut (R-C). Only partially tighten the
Nuts until the Footboard has been connected. Repeat for other Bed Rail.
7. Position and connect the Footboard (F-A) to the other end of the Bed Rails,
attaching as in the previous Steps.
8. Carefully align the Footboard to be 'square' with the Headboard. Using
the Open Wrench (R-F) tighten all Hex Nuts attaching the Side Rails to
the Headboard and Footboard. (See Detail E ).
9. Attach the four Support Legs (F-C) to the bottom side of
four Wood Slats (F-B). (See Detail F).
10. Position and attach the Slats to the Bed Rails using
the Wood Screws (F-D) and your Phillips Screwdriver.
The levelers located at the bottom of the Support Legs
can be adjusted if necessary to support the Slats.
Corinne
Bed Room
FURNITURE
Assembly Instructions
8 pcs.
12mm Open Wrench
8 pcs.
8 pcs.
Hex Nut
8 pcs.
Page 1 of 2
Made in Viet Nam
6/6 Eastern
King Bed
21580 6/0-6/6 Panel Headboard
21581 6/0-6/6 Panel Footboard
21572 5/0-6/6 Bed Rails
Be sure to check all packing
material carefully for small
parts, which may have come
loose inside the carton during
shipment. To prevent possible
scratches or damage, this furniture
should be assembled on a soft
surface such as a blanket or carpet.
Headboard