Sony SU-WL31 Instructions (SU-WL31 Wall-Mount Bracket) Instructions Manual page 7

Step 2:
Changing the position
of the arm bases
(Except for the TV
KDL-S23A1s*/
KLV-S23A1s*)
* In the actual model names, the "s" indicates numbers
and/or characters specific to each model.
If you are installing the TV KDL-S23A1s*/KLV-
S23A1s*, do not change the position of the arm
bases.
1 Remove the four angle adjust screws (two on
each side) that secure the stabilizer arms to
the left and right arm bases A.
2 Remove the screws that secure the left and
right arm bases B to the Plate Unit.
3 Remove the screws that secure the left and
right arm bases A to the Plate Unit.
4 Move the arm bases A to the inner position,
inserting them into the top left and right
inner slots, and replace the screws from
step 3.
5 Move each assembly (stabilizer arm and arm
base B) to the inner position, inserting the
arm bases B into the bottom left and right
Inner slots, and replace the screws from
step 2.
6 Secure the stabilizer arms using the angle
adjust screws from step 1.
Stabilizer arm
Arm base B
1
3
Arm base A
Stabilizer arm
5
6
4
4
Note
When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 Kgf·cm}.
2
Arm base B
2
1
Angle adjust screw
5
5
6
Angle adjust screw
7
(GB)