Sony SU-WL31 Instructions (SU-WL31 Wall-Mount Bracket) Instructions Manual page 13

2
Install the TV onto the Plate
Unit.
1 Insert the screws (+B5 L12, supplied) for
securing the Mounting Hook Unit into the
screw holes on the outer left and right sides
of the arm bases B, and then tighten them
temporarily.
Arm base B
Note
If the temporarily attached screws for securing the
Mounting Hook Unit protrude inside the arm bases,
the lower hooks of the Mounting Hook Units cannot
be fitted in.
Tighten the screws to halfway
so that they do not protrude
from the opposite side.
2 Hitch the upper hooks of the two Mounting
Hook Units on to the support shafts of the
stabilizer arms.
3 Place the lower hooks of the two Mounting
Hook Units so that they touch the front side
of the arm bases B.
4 Slightly push the TV toward the Plate Unit
and upward, to hitch the lower hooks of the
two Mounting Hook Units on to the arm
bases B.
2
4
3
5 Confirm the eight hooks are firmly hooked
on the four shafts on the Plate Unit.
6 Firmly tighten the securing screws screwed in
temporarily in step 1.
WARNING
Tighten the securing screws firmly (one each on
the left and right arm bases). If the screws are not
tightened enough, the TV could become detached
from the Plate Unit and fall, causing damage
and/or injury.
13
(GB)