Table of Contents
Advertisement
Lock-off button
•
The saw is equipped with a lock-off button (2) which reduces the possibility of
accidental starting.
•
The lock-off button is located on the handle above the switch trigger. You must
depress the lock-off button to pull the switch trigger.
•
The lock resets each time the trigger is released.
Note:
You can depress the lock-off button from either the left or right side.
Variable speed-controlled switch trigger
•
This tool has a variable speed switch (3) that delivers higher speed with increased
trigger pressure. Speed is controlled by the pressure you apply to the trigger.
•
To turn your saw on, depress the lock-off button and pull switch trigger down.
Release switch trigger to turn your saw off.
General cutting
•
Before cutting any type of material, be sure it is firmly anchored or clamped to
prevent slipping. Hold smaller pieces in a vice or attach to the workbench with
clamps. Always hold the saw in front of you and away from your body. Keep your
hands and feet well away from the workpiece.
•
Never feed the blade into the workpiece until the blade is at full speed. If the blade
is not at full speed, the saw may kick back causing serious personal injury.
•
Put on eye protection.
•
Clear the saw of any foreign material.
•
Mark out the line to be cut so it is easily visible.
•
Always use the right blade for the material.
•
Make sure all bolts, screws and locking levers are secure before starting tool.
•
Depress the lock-off button and press the switch trigger down to start the saw.
•
Set the base plate against the workpiece.
•
When the blade reaches full speed, slowly feed the blade into the workpiece.
•
After you complete your cut release the trigger and allow the blade to come to a
complete stop.
Advertisement
Table of Contents
