Table of Contents
Advertisement
While operating the Motorized Gemini in reverse in the 4-wheel position, DO NOT stand
behind the unit driving it toward you looking over your shoulder. The proper way to operate
the unit in reverse is to STAND BESIDE THE UNIT. DO NOT operate the Motorized Gemini in
reverse while in the 2-wheel position
1. Before each use, check for damaged or missing components. Replace damaged or
missing components immediately with Magliner replacement parts.
2. Check all fasteners, and make sure to tighten or replace loose or missing hardware.
3. Unplug the charger from the Motorized Gemini by carefully pulling the connector out of
the charger port in the throttle. Install the dust cover boot over the plug connector on
throttle to keep the charger port clean. Store the charger in a dry, clean place.
4. Always check that the propulsion system is functioning properly before beginning the day;
with the unit On, test that the unit moves forward and backward with propulsion.
5. With the unit turned Off, release the park brake and push or pull the Motorized Gemini to
make sure it is functioning properly in manual mode. Then reengage the transaxle.
The Gemini can be stored in any position as the batteries are sealed and there are no fluids
to leak out. The most common (and suggested) storage orientation is unloaded (empty)
in the 4 wheel position and placed on charge. Leaving the Gemini loaded for an extended
period of time is not suggested.
The most common orientation for transporting a Gemini onboard a truck is in the 2-wheel
position while secured to the truck BEFORE any transportation takes place.
1-800-MAGLINE (624-5463)
Reverse Operation
Correct
Pre-Trip Inspection
Storage and Transportation
9
Incorrect
www.magliner.com
Advertisement
Table of Contents
