Advertisement
Step 3-b (optional): Force starts function.
•
Make sure that the clamps are connected to the correct polarity battery terminal.
•
Hold the force start button for 3 seconds to enable the force start function.
•
When the indicator light of the smart clamp is solid green, the vehicle will need to
be started within 30s.
Step 4: Once your car is started, remove the battery clamp from the car battery and the
jump starter within 30 seconds.
LED Indicator
Flashing between red/green
Solid red
Rapidly flashing red
Slowly flashing green
Force start button
Ready to work/operational status
1.
Battery clamp is connected in reverse:
o
Check the orientation of the clamps on the
battery terminals
2.
The clamp is short-circuited:
o
Check whether the clamps are contacting one
another or are connected to the same piece of
metal.
3.
Reverse charging protection: the voltage of the car
battery is higher than 12.6V:
o
No jump starting is needed to start the car.
The temperature of the clamp exceeds 65 (+/-5) degrees.
Remove the clamp until the lights flash red and green.
The voltage of the jump starter is too low. Charge the
jump starter
Situations
Advertisement
