Table of Contents
Advertisement
Safety instructions for battery charger
•
Before using battery or charger, read all instructions and cautionary markings on
the battery charger, battery pack and product using the battery.
•
Use only the charger which accompanied your product or direct replacement. Do
not substitute any other charger. Use only the same supplier approved chargers
with your product.
•
Do not disassemble or operate the charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. Incorrect reassembly may result in a
risk of electric shock, electrocution, or fire.
•
Do not recharge the battery in a damp or wet environment. Do not expose the
charger to rain or snow. If the battery case is cracked or otherwise damaged, do not
insert into charger. Battery may short or fire may result.
•
Charge only supplier approved rechargeable batteries. Other types of batteries
may burst and cause personal injury or damage.
•
Charge battery pack in temperatures above 0ºC and below 45ºC. Store the tool
and battery pack in locations where temperatures will not exceed 49ºC. This is
important to prevent serious damage to the battery cells.
•
Pull by the plug rather than the cord when disconnecting charger or when
disconnecting cords. This will reduce the risk of damage to the electric plug and
cord.
•
Make sure that cord is located so that it will not be stepped on, tripped over or
otherwise subjected to damage or stress.
•
Do not use an extension cord unless it is necessary. Use of improper extension cord
could result in a risk of fire, electric shock or electrocution.
•
Do not operate charger with damaged cords or plugs - have them replaced
immediately.
•
Disconnect the charger from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
Advertisement
Table of Contents
