Advertisement
Made in America
Wand Control Operating Instructions
To rotate the vanes, rotate the wand in the direction you want the vanes rotated. To traverse the
vanes, rotate the vanes to the open position. Then, push or pull the wand to open (stack vanes) or
close (unstack vanes) the blind. If vanes are installed with the front of the vane facing the wand,
the wand will be in front of the vanes when the blind is rotated closed. If the vanes are installed
with the back of the vane facing the wand, the wand will be behind the vanes when the blind is
rotated closed.
Cord & Chain Control Operating Instructions
To rotate the vanes, gently pull the metal bead chain. To traverse the vanes, gently pull on the
nylon cord. For proper traversing of the vanes, it is critical that the vanes be rotated to the open
position prior to pulling on the cord to draw the vanes across the window opening.
If vanes become tangled or have moved out of alignment with use, re-adjustment is simple. With
your hand, gently adjust the vanes so that are all facing the same direction. Make certain that the
vanes are overlapping each of other in the correct direction. Pull the metal bead chain until you
hear a grinding sound. Give the chain an additional gentle pull. This grinding noise comes from
the vane carriers realigning themselves. Now pull the chain in the opposite direction and all the
vanes will be aligned correctly.
Tips for Preventing Louver Misalignment
Avoid leaving the window open during inclement, windy weather. Completely open (traverse) the
blinds before opening the window. Do not allow children or pets to pass through the closed blind.
2612 West Townley Ave, Suite 5, Phoenix, AZ 85021
VOM-3
Revision 110420
Phone: 602-995-9659 Fax: 602-995-7157
Advertisement
