Advertisement
Disposal of Yo
our Old Appliance
1. When this crossed-ou
1
symbol is attached
means the produc
the European Dire
2. All electrical and elec
2
should be dispose
from the municipa
via designated col
appointed by the g
the local authoritie
3. The correct disposal
3
appliance will help
potential negative
for the environme
health.
For this product'
's recycling informatio
directive, please
e send an e-mail to wee
13
determined at the highest certified power level, the
actual SAR level of the device while operating can be well
below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use
only the power required to reach the network. In general,
the closer you are to a wireless base station antenna, the
lower the power output.
The exposure standard for wireless devices employing a
unit of measurement is known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.
This device is complied with SAR for general
population/uncontrolled exposure limits in ANSI/IEEE
C95.1-1992 and had been tested in accordance with the
measurement methods and procedures specified in
IEEE1528.
The FCC has granted an Equipment Authorization for this
model phone with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR
information on this model phone is on file with the FCC
and can be found under the Display Grant section of
www.fcc.gov/oet/ea/fccid after searching on FCC ID:
SRQ-ZTEA51V. The FCC ID also can be found on the
device when you open Settings >About phone > FCC ID.
For this device, the highest reported SAR value for usage
against the head is 0.651 W/kg, and for usage near the
body is 0.823 W/kg.
While there may be differences between the SAR levels
of various phones and at various positions, they all meet
the government requirements.
SAR compliance for body-worn operation is based on a
15
ut wheeled bin
d to a product, it
ct is covered by
ective 2012/19/EU.
ctronic products
d of separately
al waste stream
lection facilities
government or
es.
of your old
p prevent
e consequences
ent and human
on based on WEEE
ee@zte.com.cn
EU DECLARATION OF CONFORMITY
Hereby, ZTE Corporation declares that the radio
equipment type ZTE Blade A51 is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration of conformity is
available at the following Internet address:
https://certification.ztedevices.com
ErP Conformity
The external power supply of this product conforms to
the Energy-related Product Directive (ErP) 2009/125/EC
of the European Parliament and the Council.
The detailed ErP information is available on ZTE website
https://certification.ztedevices.com.
RF Exposure Information (FCC SAR)
This phone is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission
of the United States.
During SAR testing, this device was set to transmit at its
highest certified power level in all tested frequency bands,
and placed in positions that simulate RF exposure in
usage against the head with no separation, and near the
body with the separation of 15 mm. Although the SAR is
14
separation distance of 15 mm between the unit and the
human body. Carry this device at least 15 mm away from
your body to ensure RF exposure level compliant or lower
to the reported level. To support body-worn operation,
choose the belt clips or holsters, which do not contain
metallic components, to maintain a separation of 15 mm
between this device and your body.
RF exposure compliance with any body-worn accessory,
which contains metal, was not tested and certified, and
using such body-worn accessory should be avoided.
FCC Regulations
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION:
Changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate
the equipment.
Co-location of this product with other transmitters that
operate simultaneously are required to be evaluated
using the FCC multi-transmitter procedures.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
16
Advertisement
