Advertisement
INSTALLATION & SETUP
1.
Screw the connecting nut of the float component into the lower barrel. DO
NOT OVER TIGHTEN.
2.
Remove the bottle support on your water dispenser by turning counter-
clockwise and lifting it up. Then insert the lower barrel into the diversion
basin.
3.
Screw the filter core into the connecting threads at the bottom of the
upper barrel. Securely tighten the filter to the upper barrel to make a tight
seal for improved filtration and to reduce the possibility of a leak.
4.
Put the upper barrel with the filter core in the lower barrel. Add water to
the upper barrel and you will be good to go.
FILLING THE FILTRATION SYSTEM
1.
Remove the top cover.
2.
Pour cold tap water into the upper barrel. (For best results, always use
"COLD" tap water) NEVER USE HOT WATER! NEVER REMOVE THE WATER
6
http://www.NewAir.com
Advertisement
